Tools & Building Supplies

Dampen motor vibrations with these 3D printed TPU FPV motor soft mounts. Placing these between your motor and frame will reduce the vibrations whic...

A rubberized, low cost, 220mm battery strap! Hold down those Batteries tight! This strap is 30mm shorter than our last strap, with 5mm longer velcr...

This DIY wiring kit takes the guesswork out of hunting for compatible wires to connect your camera and AIO board.  Some AIO boards, like the HappyM...

Whether you are flying 180, 200, 220, 250 or even  300 size quad... these neoprene landing pads are perfect for every quad!  With the ability to ta...

For the serious builders who want to style up their quad with colored accents, this is where these come in.  Pick between Green, Blue, Orange, Red,...

This adapter cable goes from XT60 or XT30 to male brass banana plugs. These are great for smaller single battery chargers that have positive and ne...

Single right angle / 45° degree SMA adapter.  Only one connector is included.  Check out all our pigtails, adapters and connectors! Includes 1x ...

This is that adhesive backed fabric tape you've probably seen holding motor wires on lots of pre-built micros. It's super handy stuff and its matte...

Do you feel the separation between your craft and its power source? Time to blur that line and make the 2 feel as 1... LiPo-Lock not only helps sup...

A rubberized, low cost, 250mm battery strap! Hold down those Batteries tight! The length of the strap is measured without the buckle. Check out the...

A rubberized, low cost, 155mm battery strap! Hold down those Mini Batteries tight!  The length of the strap is measured without the buckle. Check o...

RDQ is proud to present the Lipo Suction! The Lipo Suction discharges unused batteries down to 3.8v per cell. Storing at 3.8V per cell eliminates r...

Desoldering wick is a copper braid used in the rework and repair of printed circuit boards, computers, cell phones or other electronics. Desolderin...

High quality silicone insulated wire. 1 ft. of each*, red and black. Choose the gauge you'd like! Available Gauges  12 AWG 14 AWG 16 AWG 18 AWG...

A high quality MMCX to SMA pigtail. Available in different lengths.  Be sure to check out our tools & building supplies! Specifications Connec...

This set of 4 M3 silicone rubber vibration dampeners gummies work great to help reduce flight controller vibrations on your quad. Also available in...

Dont toss your battery just because the balance leads got chewed up in your props! Repair the balance leads on your 4S batteries! Note: Please chec...

Decent, cheap snips. Ideal for cutting wire, sprue, zip ties, plastic, and can be used to trim thin copper, brass, iron and aluminum. For thicker m...

Shave off grams with these high-quality lightweight titanium bolts. Check out the rest of our hardware! Specifications Dimensions: M3x8mm Materia...

Shave off grams with these high-quality lightweight titanium bolts. Check out the rest of our hardware! Specifications Dimensions: M3x25mm Materi...

Twenty-pieces of M3 SAE 304 Stainless Steel button head bolts/screws.  Durable reliable steel bolts for those M3 builds. Check out the rest of our ...

This U.FL Extension cable will allow you to put your U.FL antenna anywhere you need it. This is available in 76mm (3in) or 152mm (6in) lengths. Che...

Connect your SMA antennas to your DJI goggles and air units with these adapters. Check out all our pigtails, adapters and connectors! Includes 2x ...

Typically used to connect a device with female a XT60 plug to a DC power supply, lead acid, SLA, or Pb field battery using Alligator clips. Check o...

Anti-skid silicone pad for your LiPo batteries. Just peel off the backing and stick to any surface. Check out our other building tools and supplies...

These little nitrile rubber orings are super convenient stack spacers! This size can be used on M3 hardware, and stacked as many times as needed fo...

Individual anodized aluminum M2 countersunk washers in a variety of colors sure to suit your next build.  Sold individually, so be sure to select t...

Power cable for the TS100. We also carry the RDQ Tool kit for all of your on-the-go repair! Be sure to check out our tools & building supplies!...

Please note these do not have the nylon insert found in typical prop nuts.These are unique low profile prop nuts with a pattern on the bottom of th...

JR type servo extensions with flat bonded wire. Available in multiple lengths. Wire color may vary as well as the wires being braided vs bonded.We ...

A note from GNB: We define this connector's "gender" by plastic not by metal bullet. Female is used on the Drone side while Male is used on the Bat...

A set of 5 surface mount ufl connectors.With a little patience, repairing broken VTX and RX antenna connectors is worth the effort! Check out all o...

A barbell style standoff with smooth edges in assorted colors! Choose your color and size preference. Check out all our hardware and the rest of ou...

Dont toss your battery just because the balance leads got chewed up in your props! Repair the balance leads on your 2S batteries!  Note: Please che...

RX antenna tube holders compatible with both the normal and knurled standoffs.  The antenna tubes are at a 45 degree angle and come in sets of 2.  ...

Never worry about struggling to tighten that SMA connection again with the SMA Grip! Others have a plastic SMA nuts that easily break upon impact b...

Connect your RP-SMA DJI antennas to standard SMA pigtails with these adapters. If you're trying to connect an SMA antenna to the DJI Goggles this w...

This 3D printed antenna holder attaches to any standoff, making antenna mounting a breeze! Check out all our 3D printed accessories! Includes 1x A...

Bullet connectors for ESC / Motor connection, or wires you want to easily disconnect. Pack of 3, available in multi sizes. Here are some guidelines...

MMCX to SMA Adapter Connector Check out all our pigtails, adapters and connectors! Includes 1x MMCX Male to SMA female adapter

Spare / replacement heavy gauge XT30 pigtail with capacitor. We also carry a 20AWG version. Check out the rest of our pigtails & connectors! Sp...

Individual anodized aluminum M2 flanged nylon lock nuts in a variety of colors sure to suit your next build.  Sold individually, so be sure to sele...

Dont toss your battery just because the balance leads got chewed up in your props! Repair the balance leads on your 3S batteries! Note: Please chec...

Keep those nuts, bolts and screws from rolling off the table with the RDQ screw tray! Check out our other RDQ building tools and supplies! Note: Th...

Individual anodized aluminum M3 stepped washers for button / pan head screws in a variety of colors sure to suit your next build.  Sold individuall...